Alcatel-Lucent 7450 Manual page 399

memory-usage
Syntax memory-usage
Context tools>dump>router>mpls
Description
This command dumps memory usage information for MPLS.
adjust-autobandwidth
Syntax adjust-autobandwidth [lsp lsp-name [force [bandwidth mbps]]]
Context tools>perform>router>mpls
Description This command initiates an immediate automatic bandwidth adjustment attempt for either one specific
LSP or all active LSPs. The automatic bandwidth adjustment is made to the primary or secondary
path of the LSP, whichever is the currently active path. If an LSP is not specified, then the system
assumes the command applies to all LSPs. The optional force parameter, which is available only
when an LSP is referenced, determines whether adjust-up and adjust-down threshold checks are
applied. If force is not specified then the maximum average data rate must differ from the current res-
ervation by more than the adjust-up or adjust-down thresholds, otherwise no bandwidth adjustment
occurs. If the force option is specified then, bandwidth adjustment ignores the configured thresholds.
If a bandwidth is specified as part of the force option then the bandwidth of the LSP is changed to this
specific value, otherwise the bandwidth is changed to the maximum average data rate that has been
measured by the system in the current adjust interval.
The adjust-count and maximum average data rate are not reset by the manual auto-bandwidth com-
mand, whether or not the bandwidth adjustment succeeds or fails. The overflow count is reset only if
the manual auto-bandwidth attempt is successful.
Default none
Parameters
lsp-name — The name of the LSP to which this command applies. If this parameter is not supplied
mbps — The bandwidth that the LSP should be immediately resized to.
7450 ESS MPLS Guide
the command applies to all active LSPs.
Values String (32 chars max)
Default none
Values 0—100000
Default
none
MPLS and RSVP
Page 399