Alcatel-Lucent 7450 Manual page 235

swap
Syntax swap {out-label | implicit-null-label} nexthop ip-address
no swap {out-label | implicit-null-label}
Context config>router>mpls>interface>label-map
Description
This command swaps the incoming label and specifies the outgoing label and next hop IP address on
an LSR for a static LSP.
The no form of this command removes the swap action associated with the in-label.
Default none
Parameters implicit-null-label — Specifies the use of the implicit label value for the outgoing label of the swap
out-label — Specifies the label value to be swapped with the in-label. Label values 16 through
nexthop ip-address — The IP address to forward to. If an ARP entry for the next hop exists, then the
mpls-tp-mep
Syntax [no] mpls-tp-mep
Context config>router>mpls>interface
Description
This command enables the context for a section layer MEP for MPLS-TP on an MPLS interface.
Default none
7450 ESS MPLS Guide
operation.
1,048,575 are defined as follows:
Label values 16 through 31 are reserved.
Label values 32 through 1,023 are available for static assignment.
Label values 1,024 through 2,047 are reserved for future use.
Label values 2,048 through 18,431 are statically assigned for services.
Label values 28,672 through 131,071 are dynamically assigned for both MPLS and services.
Label values 131,072 through 1,048,575 are reserved for future use.
Values
16 — 1048575
static LSP will be marked operational. If ARP entry does not exist, software will set the
operational status of the static LSP to down and continue to ARP for the configured nexthop.
Software will continuously try to ARP for the configured nexthop at a fixed interval.
MPLS and RSVP
Page 235