Alcatel-Lucent 7450 Manual page 364

path
Syntax path [path-name] [lsp-binding]
Context show>router>mpls
Description This command displays MPLS paths.
Parameters path-name — The unique name label for the LSP path.
lsp-binding — Keyword to display binding information.
Output MPLS Path Output — The following table describes MPLS Path output fields.
Path Name
Adm
Hop Index
IP Address
Strict/Loose
LSP Name
Binding
Paths
Sample Output
*A:SRU4>config>router>mpls# show router mpls path
===============================================================================
MPLS Path:
===============================================================================
Path Name
-------------------------------------------------------------------------------
to_110_20_1_1
to_110_20_1_2
to_110_20_1_3
to_110_20_1_4
to_110_20_1_5
Page 364
Label
The unique name label for the LSP path.
Down — The path is administratively disabled.
Up — The path is administratively enabled.
The value used to order the hops in a path.
The IP address of the hop that the LSP should traverse on the way to
the egress router.
Strict — The LSP must take a direct path from the previous hop
router to the next router.
Loose — The route taken by the LSP from the previous hop to the
next hop can traverse through other routers.
The name of the LSP used in the path.
Primary — The preferred path for the LSP.
Secondary — The standby path for the LSP.
Total number of paths configured.
Description
Adm Hop Index IP Address
Up no hops n/a
Up no hops n/a
Up no hops n/a
Up no hops n/a
Up no hops n/a
Strict/Loose
n/a
n/a
n/a
n/a
n/a
7450 ESS MPLS Guide