Figure 18: Bfd Used For Proactive Cv On Mpls-Tp Lsp - Alcatel-Lucent 7450 Manual

MPLS-TP Maintenance Identifiers
BFD Packet Injected Into LSP 2
LER A
Mis-connection
(Mis-swap)
Linear protection switching of LSPs (see below) is triggered based on a CC or CV defect detected
by BFD CC/CV.
Note that RFC6428 defines two BFD session modes: Coordinated mode, in which the session state
on both directions of the LSP is coordinated and constructed from a single, bidirectional BFD
session, and independent mode, in which two independent sessions are bound together at a MEP.
Coordinated mode is supported.
BFD is supported on MPLS-TP LSPs. When BFD_CV detects a mis-connectivity on an LSP, the
system will drop all incoming non-OAM traffic with the LSP label (at the LSP termination point)
instead of forwarding it to the associated SAP or PW segment.
The following GACh channel types are supported for the combined CC/CV mode:
•
•
The following G-ACh channel types are used for the CC-only mode:
•
Page 72
LSP1
LSR A
LSP2

Figure 18: BFD used for proactive CV on MPLS-TP LSP

0x22 for BFD CC with no IP encapsulation
0x23 for BFD CV
0x07
LSR B LER B
LSR B LER C
BFD Packet Received on LSP 1
al_0232
7450 ESS MPLS Guide