Alcatel-Lucent 7450 Manual page 404

In the specific case where the name corresponds to a manual bypass LSP, the LSP is torn down and
re-signaled using the new path provided by CSPF if no PSB associations exist. If there is one or more
PSB association but no PLR is active, the command is failed and the user is asked to explicitly enter
the force option. In this case, the manual bypass LSP is torn down and re-signaled, leaving temporar-
ily the associated LSP primary paths unprotected. Finally, if one or more PLRs associated with the
manual bypass LSP is active, the command is failed.
Parameters lsp bypass-lsp-name [force] — Specifies the name of the dynamic or manual bypass LSP. The force
delay minutes — Specifies the time, in minutes, MPLS waits before attempting to re-signal dynamic
revert
Syntax revert [lsp lsp-name]
Context tools>perform>router>mpls
Description Use this command to cause a named LSP, which is currently using a secondary path and for
which the revert-timer has been configured, to switch back to using the primary path. Any
outstanding revert-timer is canceled.
The primary path must be up for this command to be successful.
Parameters lsp-name — Specifies an existing LSP name to move.
switch-path
switch-path [lsp lsp-name] [path path-name]
Context tools>perform>router>mpls
Use this command to move from a standby (or an active secondary) to another standby of
the same priority. If a new standby path with a higher priority or a primary path comes up
after the tools perform command is executed, the path re-evaluation command runs and the
path is moved to the path specified by the outcome of the re-evaluation.
Parameters
lsp-name — Specifies an existing LSP name to move.
path-name — Specifies the path name to which to move the specified LSP.
Page 404
option is required when the name corresponds to a manual bypass LSP and the LSP has PSB
associations.
bypass LSP paths originated on the system.
Values 0 — 30
7450 ESS MPLS Guide