Alcatel-Lucent 7450 Manual page 298

RSVP Commands
update-timer
Syntax update-timer seconds
no update-timer
Context config>router>rsvp>te-threshold-update
Description
This command is to control timer-based IGP TE updates. Timer-based IGP updates can be enabled by
specifying a non-zero time value. Default value of update-timer is 0.
The no form of this command should reset update-timer to the default value and disable timer-based
IGP update.
Default no update-timer (time - 0 seconds)
Parameters
seconds — The time in seconds.
te-up-threshold
Syntax te-up-threshold threshold-level [threshold-level...(up to 16 max)]
no te-up-threshold
Context config>router>rsvp
config>router>rsvp>interface
Description This command configures the specific threshold levels per node and per interface. Threshold levels
are for reserved bandwidth per interface. The te-threshold-update command is used to enable or
disable threshold-based IGP TE updates. Any reserved bandwidth change per interface is compared
with all the threshold levels and trigger an IGP TE update if a defined threshold level is crossed in
either direction (LSP setup or teardown). Threshold-based updates must be supported with both ISIS
and OSPF. A minimum of one and a maximum of 16 threshold levels must be supported.
Threshold levels configured per node is inherited by all configured RSVP interfaces. Threshold
levels defined under the RSVP interface is used to trigger IGP updates if non-default threshold levels
are configured.
The no form of this command resets te-up-threshold to its default value.
Default
0 15 30 45 60 75 80 85 90 95 96 97 98 99 100
Parameters threshold-level — Integer value
Page 298
Values 0-300
Values
0 — 100
7450 ESS MPLS Guide