Alcatel-Lucent 7450 Manual page 468

LMP Commands
Default
no peer-loopback-address
Parameters ip-address — The GMPLS control plane loopback address of the IPCC next-hop.
retransmission-interval
Syntax retransmission-interval milliseconds
Context config>router>lmp>peer
Description This command specifies the interval between resubmitted LMP messages.
Default n/a
Parameters milliseconds — Specifies the retransmission interval, in milliseconds.
retry-limit
Syntax retry-limit limit
no retry-limit
Context config>router>lmp>peer
Description
This command specifies how many times LMP resends a message before restarting the process.
Default no retry-limit
Parameters limit — Specifies the number of reattempts.
te-link
Syntax [no] te-link te-link-id
Context config>router>lmp>peer
Description This command assigns a Traffic Engineering (TE) Link to a given LMP peer. The TE Link with ID
te-link-id must already have been created under config>router>lmp>te-link.
Default no te-link
Page 468
Values
ipv4-address — a.b.c.d
ipv6-address — x:x:x:x:x:x:x:x (eight 16-bit pieces)
Values 1 — 4294967295
Default 500
Values 1 — 4294967295
x:x:x:x:x:x:d.d.d.d
x — [0..FFFF]H
d — [0..255]D
7450 ESS MPLS Guide