Alcatel-Lucent 7450 Manual page 318

To
Adm State
Oper State
Oper State
LSPs
From
LSP Up Time
Transitions
Retry Limit
Signaling
Hop Limit
Fast Reroute/
FastFail Config
ADSPEC
Primary
Secondary
Bandwidth
LSP Up Time
LSP Tunnel ID
Page 318
Label
The system IP address of the egress router for the LSP.
Down — The path is administratively disabled.
Up — The path is administratively enabled.
Down — The path is operationally down.
Up — The path is operationally up.
Down — The path is operationally down.
Up — The path is operationally up.
The total number of LSPs configured.
The IP address of the ingress router for the LSP.
The length of time the LSP has been operational.
The number of transitions that have occurred for the LSP.
The number of attempts that the software should make to re-establish
the LSP after it has failed.
Specifies the signaling style.
The maximum number of hops that an LSP can traverse, including the
ingress and egress routers.
enabled — Fast reroute is enabled. In the event of a failure, traffic
is immediately rerouted on the pre-computed detour LSP, thus mini-
mizing packet loss.
disabled — There is no detour LSP from each node on the primary
path.
enabled — The LSP will include advertising data (ADSPEC)
objects in RSVP messages.
disabled — The LSP will not include advertising data (ADSPEC)
objects in RSVP messages.
The preferred path for the LSP.
The alternate path that the LSP will use if the primary path is not avail-
able.
The amount of bandwidth in megabits per second (Mbps) reserved for
the LSP path.
The total time in increments that the LSP path has been operational.
The value which identifies the label switched path that is signaled for
this entry.
Description (Continued)
7450 ESS MPLS Guide