Alcatel-Lucent 7450 Manual page 672

fec129-cisco-interop
Syntax
Context
Description
Default
fec-type-capability
Syntax
Context
Description
p2mp
Syntax
Context
Description
Page 672
log-only — Specify only a trap and syslog message are generated when reaching the threshold and
limit. However, LDP labels are not released back to the peer.
threshold percent — Specify the threshold value (as a percentage) that triggers a warning syslog
message and trap to be sent.
[no] fec129-cisco-interop
config>router>ldp>session-parameters>peer
This command specifies whether LDP will provide translation between non-compliant FEC 129
formats of Cisco. Peer LDP sessions must be manually configured towards the non-compliant Cisco
PEs.
When enabled, Cisco non-compliant format will be used to send and interpret received label release
messages i.e. the FEC129 SAII and TAII fields will be reversed.
When the disabled, Cisco non-compliant format will not be used or supported. Peer address has to be
the peer LSR-ID address.
The no form of the command returns the default.
no fec129-cisco-interop
fec-type-capability
config>router>ldp>session-parameters>peer
config>router>ldp>interface-parameters>interface>ipv4
config>router>ldp>interface-parameters>interface>ipv6
This command enables or disables the advertisement of a FEC type on a given LDP session or Hello
adjacency to a peer.
p2mp {enable | disable}
config>router>ldp>session-parameters>peer>fec-type-capability
This command enables or disables P2MP FEC capability for the session.
7450 ESS MPLS Guide