Configuring Sntp Using Edm - Avaya 4524GT Configuration Manual

Procedure steps
1. From the Device Physical View, click a port.
2. From the navigation tree, double-click Graph.
3. In the Graph tree, double-click Port .
4. In the work area, click the Bridge tab.
5. On the toolbar, select a value from the Poll Interval list.
6. To reset the statistics counters, click Clear Counters.
7. To select bridge statistical information to graph, click a data row under a column
8. On the toolbar, click Line Chart, Area Chart, Bar Chart, or Pie Chartcolumn.
Variable definitions
Use the data in the following table to help you understand port bridge statistics.
Variable
DelayExceededDiscards
MtuExceededDiscards
InFrames
OutFrames
InDiscards

Configuring SNTP using EDM

Use the following procedure to configure Simple Network Time Protocol (SNTP).
Configuration — System
heading.
Number of frames discarded by the port due to excessive
transit delays through the bridge. It is incremented by both
transparent and source route bridges.
Number of frames discarded by the port due to an excessive
size. It is incremented by both transparent and source route
bridges.
The number of frames that have been received by this port
from its segment.
The number of frames that have been received by this port
from its segment.
Count of valid frames received which were discarded (filtered)
by the Forwarding Process.
Configuring SNTP using EDM
Value
April 2011 275