Flash Memory Storage; Switch Software Image Storage; Configuration Parameter Storage - Avaya 4524GT Configuration Manual

The source IPv6 node then resends a packet equal to the size of the MTU included in the ICMP
message.
The default MTU value for a regular interface is 1500.

Flash memory storage

The sections in this module describe flash memory for software image upgrades.

Switch software image storage

The switch software image storage; uses flash memory to store the switch software image.
You can update the software image with a new version from flash memory.
You must have an in-band connection between the switch and the TFTP load host to the
software image.
Important:
When you use the TFTP address parameter to perform copy or download commands, the
system overwrites the TFTP server address

Configuration parameter storage

All configuration parameters in the configuration parameter storage; are stored in flash
memory.
These parameters are updated every 60 seconds if a change occurs, or upon execution of a
reset command.
Important:
Do not power off the switch within 60 seconds of changing any configuration parameters.
If the switch is powered down within 60 seconds, any changes made to the configuration
parameters can be lost.
Configuration — System
Flash memory storage
April 2011 39