Default Ip Address - Avaya 4524GT Configuration Manual

Parameters
stack | switch | unit
Important:
When you change the IP address or subnet mask, connectivity to Telnet and the Web can
be lost.
default ip address command
The default ip address command sets the IP address, subnet mask, and boot mode for
the switch or a stack to default.
The syntax for the default ip address [source] command is

default ip address

Run the default ip address command in Global Configuration command mode.
The following table describes the parameters for the default ip address command.
Table 49: default ip address parameters
Variable
source
Important:
When the IP gateway changes, connectivity to Telnet and the Internet can be lost.
no ip address command
The no ip address command clears the IP address and subnet mask for a switch or a stack.
This command sets the IP address and subnet mask for a switch or a stack to all zeros (0).
The syntax for the no ip address command is
no ip address {stack | switch | unit}
Configuration — System
• configured-address—use configured server IP address
• dhcp-always—always use the DHCP server
• dhcp-last-address—use the DHCP server last used
• dhcp-when-needed—use the DHCP server when needed
Specifies the IP address and netmask of the stack or the switch,
or another unit in at a stack.
Configures the BootP and DHCP boot mode to default for the
next system reboot.
General switch administration using ACLI
Description
Value
April 2011 133