Serial Security - Avaya 4524GT Configuration Manual

Important:
To remove all three server addresses, you must enter the command three times, each with
a different server address.
Table 73: no ip name-server parameters
command.
Table 73: no ip name-server parameters
<ip_address_1>
<ip_address_2>
<ip_address_3>
Run this command in Global Configuration command mode.

Serial Security

This feature involves logout event when serial console is pulled out.
The commands for serial security are:
4548GT-PWR(config)#serial-security enable
- Enable serial security
4548GT-PWR(config)#no serial-security enable
- Disable serial security
4548GT-PWR(config)#default serial-security enable
Important:
By default this feature is disabled, the show serial-security command displays the
status of the serial security.
Following is an example for show serial-security command:
4548GT-PWR#show serial-security
Serial security is disabled
The following message should be logged during the logout event:
Configuration — System
Parameter
General switch administration using ACLI
on page 163 outlines the parameters for this
Description
The IP address of the domain name server to
remove.
Optional. The IP address of a domain name server to
remove from the list of servers used by the switch.
Optional. The IP address of a domain name server to
remove from the list of servers used by the switch.
April 2011 163