Setting Up A Terminal - Avaya 4524GT Configuration Manual

System configuration using ACLI
Prerequisites
Log on to the Privileged EXEC mode in ACLI.
Procedure steps
Enter the following command:
show usb-host-port [unit <1-8>]
Table 31: show usb-host-port parameters
unit <1-8>

Setting up a terminal

You can customize switch terminal settings to suit the preferences of a switch administrator.
You must perform this operation in the Command Line Interface.
The terminal command configures terminal settings. These settings include terminal length
and terminal width.
The syntax of the terminal command is:
terminal length <0-132> width <1-132>
Run the terminal command in User EXEC command mode. The following table describes the
for the terminal command.
Table 32: terminal parameters
length
width
96 Configuration — System
Variable
Variable
Description
Specifies a specific switch unit within a stack. Values
range from 1 to 8.
Description
Set the length of the terminal display in lines; the
default is 23.
Important:
If you set the terminal length to 0, the pagination is
disabled and the display scrolls continuously.
Set the width of the terminal display in characters; the
default is 79.
April 2011