Configuring The Ipv4 Remote Access List Using Edm - Avaya 4524GT Configuration Manual

Web Page Remote Access Setting
SSH Remote Access Setting

Configuring the IPv4 remote access list using EDM

Use this procedure to configure a list of IPv4 source addresses for which to permit remote
access to a switch.
Procedure steps
1. From the navigation tree, double-click Administration.
2. In the Administration tree, double-click Remote Access .
3. In the work area, click the Allowed List(IPv4) tab.
4. To select a source to edit, click the source row.
5. In the source row, double-click the cell in the Allowed Source IP Address
6. In the dialog box, type a value.
7. In the source row, double-click the cell in the Allowed Source Mask column.
8. In the dialog box, type a value.
9. Click Apply .
Configuration — System
Variable
column.
Configuring the IPv4 remote access list using EDM
Value
• Access—allows or disallows SNMP
access to the switch
• Use List—enables (Yes) or disables (No)
the use of listed remote SNMP
information.
Specifies web page remote access
settings.
Use List—enables (Yes) or disables (No)
the use of listed remote web page
information.
Specifies SSH remote access settings.
• Access—allows or disallows SSH access
to the switch
• Use List—enables (Yes) or disables (No)
the use of listed remote SSH information.
April 2011 213