System configuration using ACLI
restore factory-default [-y]
the [-y] parameter instructs the switch not to prompt for confirmation.
Configuring IPv6
Use the following procedures to configure IPv6:
•
Enabling IPv6 interface on the management VLAN
•
Configuring IPv6 interface on the management VLAN
•
Displaying the IPv6 interface information
•
Displaying IPv6 interface addresses
•
Configuring an IPv6 address for a switch or stack
•
Displaying the IPv6 address for a switch or stack
•
Configuring IPv6 interface properties
•
Disabling IPv6 interface
•
Displaying the global IPv6 configuration
•
Configuring an IPv6 default gateway for the switch or stack
•
Displaying the IPv6 default gateway
•
Configuring the IPv6 neighbor cache
•
Displaying the IPv6 neighbor information
•
Displaying IPv6 interface ICMP statistics
•
Displaying IPv6 interface statistics
•
Displaying IPv6 TCP statistics
•
Displaying IPv6 TCP listeners
•
Displaying IPv6 UDP statistics and endpoints
You can only execute ACLI commands for IPv6 interface configuration on the base unit of a
stack. Use the Global Configuration mode to execute IPv6 commands.
Enabling IPv6 interface on the management VLAN
Use the following procedure to enable an IPv6 interface to the management VLAN:
114
Configuration — System
on page 115
on page 116
on page 118
on page 120
on page 120
on page 121
on page 121
on page 122
on page 122
on page 123
on page 124
on page 125
on page 114
on page 115
on page 117
on page 118
on page 121
on page 125
April 2011