Configuring The Poe Conservation Level Request Tlv Using Acli - Avaya 4524GT Configuration Manual

System configuration using ACLI
show lldp med-network-policies [port <portList>] {voice|voice-
signaling}
Run the show lldp med-network-policies command in Privileged EXEC command
mode.
The following table describes the variables for the show lldp med-network-policies
command.
Table 92: show lldp med-network-policies command variables
port <portlist>
voice
voice-signaling
Note:
The default DSCP value is 46 and the default priority value is 6.

Configuring the PoE conservation level request TLV using ACLI

Use this procedure to request a specific power conservation level for an Avaya IP phone
connected to a switch port.
Prerequisites
Log on to the Interface Configuration mode in ACLI.
Procedure steps
1. Configure PoE conservation level TLVs for connected Avaya IP phones by using
2. Set PoE conservation level TLVs for connected Avaya IP phones to the default value
180 Configuration — System
Variable
the following command:
lldp [port <portList>] vendor-specific avaya poe-
conservation-request-level <0-255>
by using the following command:
default [port <portList>] lldp vendor-specific avaya poe-
conservation-request-level
Specifies the port or ports for which to display LLDP
MED policy information.
Displays the voice network policy for which to display
information. The default value is 46.
Specifies the voice signalling network policy to
disable.
Value
April 2011