System configuration using ACLI
Setting the asset ID string to default
Perform this procedure to set the asset ID string to default mode.
Prerequisites
Log on to Global configuration mode.
Procedure steps
1. To set the asset ID string to default enter the following command:
2. To verify the asset ID string settings enter the following command:
Variable definitions
Use the data in the following table to complete this procedure.
Stack
Unit <1-8>
AES configuration using ACLI
You can use Avaya Energy Saver (AES) to configure the switch to utilize energy more
efficiently.
Configuring global AES using ACLI
Use the following procedure to enable or disable the energy saving feature for the switch.
200
Configuration — System
default asset-id [ stack | unit <1-8> | <cr> ]
show system
Variable
Sets the default Asset ID of the stack
Sets the default Asset ID for specified unit Unit number:
1–8
Value
April 2011