Default Telnet-Access Command; Setting Boot Parameters Using Acli; Boot Command - Avaya 4524GT Configuration Manual

Variables

default telnet-access command

The default telnet-access command sets the Telnet settings to the default values.
The syntax for the default telnet-access command is
default telnet-access
Run the default telnet-access command in Global Configuration command mode.

Setting boot parameters using ACLI

The command described in this section is used to boot the switch or stack and to set boot
parameters.

boot command

The boot command performs a soft-boot of the switch or stack.
The syntax for the boot command is
boot [default] [unit <unit no>]
Run the boot command in Privileged EXEC command mode.
The following table describes the parameters for the boot command.
Table 35: boot parameters
Variables
default
unit <unit no>
Configuration — System
Important:
These same source IP addresses are in the IP Manager list.
For more information about the IP Manager list, see Chapter
3.
Restore switch or stack to factory-default settings after rebooting.
Specify which unit of the stack is rebooted. This command is
available only in stack mode. Enter the unit number of the switch you
want to reboot.
Setting boot parameters using ACLI
Description
Description
April 2011 99