Reload Command - Avaya 4524GT Configuration Manual

System configuration using ACLI
Table 40: Shutdown command variables
Variables
force
minutes-to-wait <1-60>
cancel
Important:
Any configurations or logins performed on the switch after you initiate the shutdown
command are not saved to NVRAM and are lost after the reset.
Run the shutdown command in privExec command mode.

Reload command

The reload ACLI command provides you with a configuration rollback mechanism to prevent
loss of connectivity to a switch, typically for remote configurations.
Use the reload command to temporarily disable the autosave feature for a specified time
period, so you can make configuration changes on remote switches without affecting the
currently saved configuration.
During the interval in which the autosave feature is disabled by the reload command, you
must use the copy config nvram command to manually save your configurations.
Initiate the reload command before you start the switch configuration commands. After you
initiate the command in ACLI, the following message appears:
Reload (y/n) ?
Enter yes at this prompt to set the switch reload.
The following warning message appears:
Warning the switch/stack has been set to reload in <xx> minutes.
Current configuration has NOT been saved. Configuration must be
explicitly saved.
After the reload timer expires, the switch resets, reloads the last saved configuration, and re-
enables the autosave feature.
The syntax for the reload command is
reload [force] [minutes-to-wait] [cancel]
The following table describes the variables for the reload command.
112 Configuration — System
Instruct the switch to skip the shutdown confirmation prompt.
Specify the number of minutes that pass before the switch resets
itself The default wait time is 10 minutes.
Cancel all scheduled switch shutdowns.
Description
April 2011