Set power limit for channels
The poe-limit command sets the power limit for channels.
The syntax for the poe-limit command is
poe poe-limit [port <portlist>] <3-16>
Table 45: poe-limit parameters
Table 45: poe-limit parameters
port <portlist>
<3 - 16>
Run the poe-limit command in Interface Configuration command mode.
Set traps control
The poe-trap command enables PoE-related traps for PoE-enabled ports.
The syntax for the poe-trap command is
poe poe-trap [unit <1-8>]
Substitute <1-8> with the number of the unit on which to enable traps.
Show main power status
The show poe-main-configuration command displays the power configuration.
The syntax for the show poe-main-configuration command is
show poe-main-status [unit <1-8>]
Substitute <1-8> with the number of the unit for which to display the configuration.
Run the show poe-main-status command in Privileged EXEC command mode.
Configuration — System
on page 127 outlines the parameters for this command.
Parameter
Description
The ports to set the limit on
The power range to limit at from 3 to 16 W
Configuring PoE using ACLI
April 2011
127