System configuration using ACLI
Displaying the IPv6 neighbor information
Use the following command to display IPv6 neighbor information:
Enter the following command to display the address and status of the neighbor
cache.
show ipv6 neighbor [<ipv6_address>] [type {other | dynamic |
static | local}]
Job aid
The following graphic shows the output of the show ipv6 neighbor command.
4526(config)#show ipv6 neighbor
=======================================================================================
=======================================================================================
NET ADDRESS/ PHYSICAL ADDRESS
------------------------------------------------------------------------------------------------------------------------------------------------------
3000:0:0:0:0:0:0:0/ 00:11:F9:34:88:00
3000:0:0:0:0:0:0:1/ 00:01:02:03:04:05
3000:0:0:0:0:0:0:99/ 00:11:f9:34:88:00
fe80:0:0:0:211:f9ff:fe34:8800/ 00:11:f9:34:88:00
Displaying IPv6 interface ICMP statistics
Use the following procedure to display IPv6 interface ICMP statistics:
Enter the following command:
show ipv6 interface icmpstatistics [<1-4094>]
Job aid
The following graphic shows a sample of the results from the show ipv6 interface
icmpstatistics command.
122
Configuration — System
Neighbor Information
PHYS INTF
TYPE
STATE
V-1
LOCAL
REACHABLE
1/5
STATIC
REACHABLE
V-1
LOCAL
REACHABLE
V-1
LOCAL
REACHABLE
LAST
UPD
0
387452
385251
385193
April 2011