Lldp Med-Network-Policies Command - Avaya 4524GT Configuration Manual

System configuration using ACLI
status {rxOnly | txAndRx | txOnly}

lldp med-network-policies command

The lldp med-network-policies command configures LLDP Media Endpoint Devices
(MED) policies for switch ports. The syntax for the lldp med-network-policies
command is
lldp med-network-policies [port <portList>] {voice|voice-signaling}
[dscp <0-63>] [priority <0-7>] [tagging {tagged|untagged}] [vlan-id
<0-4094>]
Run the lldp med-network-policies command in Interface Configuration command
mode.
The following table describes the variables for the lldp med-network-policies
command.
Table 76: lldp med-network-policies command variables
port <portlist>
voice
voice-signaling
dscp <0-63>
priority <0-7>
tagging {tagged | untagged}
166 Configuration — System
Variables
Variable
Description
Set the LLDPU transmit and receive status on the
ports.
• rxonly: enables LLDPU receive only
• txAndRx: enables LLDPU transmit and receive
• txOnly: enables LLDPU transmit only
Specifies the port or ports on which to configure LLDP
MED policies.
Specifies voice network policy. The default value is
46.
Specifies voice signalling network policy.
Specifies the value of the Differentiated Service Code
Point (DSCP) as defined in IETF RFC 2474 and RFC
2475 that is associated with the selected switch port
or ports. Values range from 0–63. The default value is
46.
Specifies the value of the 802.1p priority that applies
to the selected switch port or ports. Values range from
0–7. The default value is 6.
Specifies the type of VLAN tagging to apply on the
selected switch port or ports.
Value
April 2011