Chapter 7: System Configuration Using Enterprise Device Manager; Configuring Quick Start Using Edm - Avaya 4524GT Configuration Manual

Chapter 7:
This chapter provides procedures you can use to configure the switch or stack with Enterprise Device
Manager (EDM).

Configuring Quick Start using EDM

Perform this procedure to configure Quick Start to enter the setup mode through a single
screen.
Procedure steps
1. From the navigation tree, double-click Administration.
2. In the Administration tree, double-click Quick Start .
3. In the IP/Community/Vlan work area, type a switch or stack IP address in the In-
4. In the In-Band Stack Subnet Mask dialog box, type a subnet mask.
5. In the Default Gateway dialog box, type an IP address.
6. In the Read-Only Community String box, type a character string.
7. In the Re-enter to verify dialog box immediately following the Read-Only
8. In the Read-Write Community String dialog box, type a character string.
9. In the Re-enter to verify dialog box immediately following the Read-Write
10. In the Quick Start VLAN dialog box, type a VLAN ID ranging from 1 to 4094.
11. Click Apply .
Configuration — System
System configuration using
Enterprise Device Manager
Band Stack IP Address dialog box.
Community String box, retype the character string from Step 6.
Community String: box, retype the character string from Step 8.
April 2011 211