Configuring An Ipv6 Address For A Switch Or Stack - Avaya 4524GT Configuration Manual

address-type <1-2>
name <1-255>
link-local <WORD 0-19>
mtu <1280-9600>
reachable-time <0-3600000>
retransmit-timer <0-3600000>
enable

Configuring an IPv6 address for a switch or stack

Use the following procedure to configure an IPv6 address for a switch or stack:
ipv6 address
Enter the following command:
ipv6 address {[<ipv6_address/prefix_length>] [stack
<ipv6_address/prefix_length>] [switch <ipv6_address/
prefix_length>] [unit <1-8> <ipv6_address/prefix_length>]}
Variable definitions
The following table defines the variables used to configure an IPv6 address for a switch or
stack.
ipv6_address/prefix_length
stack
switch
unit
Configuration — System
Variable
Variable
Definition
Address type
Name: integer from 1–255
Local link
Default status: MTU 1280
Time in milliseconds neighbor is considered
reachable after a reachable confirmation
message. Default: 30000
Time in milliseconds between
retransmissions of neighbor solicitation
messages to a neighbor. Default: 1000
Enables the interface administrative status.
Definition
IP address of stack
IP address of switch
Unit number: 1-8
Configuring IPv6
April 2011 117