Configuring The 802.1Q Framing Tlv Using Acli - Avaya 4524GT Configuration Manual

Configuring the 802.1Q framing TLV using ACLI

Use this procedure to configure the frame tagging mode for exchanging Layer 2 priority tagging
information between the switch and an Avaya IP phone.
Prerequisites
• Enable LLDP MED capabilities.
• Enable LLDP MED network policies.
• Log on to the Interface Configuration mode in ACLI.
Procedure steps
1. Configure the Layer 2 frame tagging mode by using the following command:
2. Set the Layer 2 frame tagging mode to default by using the following command:
Variable definitions
<portlist>
[tagged | non-tagged | auto]
Configuration — System
lldp [port <portlist>] vendor-specific avaya dot1q-framing
[tagged | non-tagged | auto]
default lldp [port <portlist>] vendor-specific avaya dot1q-
framing
Variable Value
Specifies a port or list of ports.
Specifies the frame tagging mode. Values
include:
• tagged—frames are tagged based on the
tagging value the Avaya IP phone receives
with the LLDP-MED Network Policy TLV.
• non-tagged—frames are not tagged with
802.1Q priority.
• auto—an attempt is made to tag frames
based on the tagging value the Avaya IP
phone receives with the LLDP-MED
Network Policy TLV. If there is no LLDP-
MED Network Policy information available,
an attempt is made to tag frames based on
server configuration. If that fails, traffic is
transmitted untagged.
The default tagging mode is auto.
Configuring LLDP using ACLI
April 2011 187