No Lldp Tx-Tlv Command; No Lldp Tx-Tlv Dot1 Command - Avaya 4524GT Configuration Manual

Table 88: no lldp med-network-policies command variables
port <portlist>
voice
voice-signaling

no lldp tx-tlv command

The no lldp tx-tlv command specifies the optional Management TLVs not to include in
the transmitted LLDPDUs. The syntax for the no lldp tx-tlv command is
no lldp tx-tlv [port <portlist>] [port-desc] [sys-name] [sys-desc]
[sys-cap] [local-mgmt-addr]
Run the no lldp tx-tlv command in Interface Configuration command mode.
The following table describes the variables for the no lldp tx-tlv command.
Table 89: default lldp tx-tlv command variables
port <portlist>
port-desc
sys-name
sys-desc
sys-cap
local-mgmt-addr

no lldp tx-tlv dot1 command

The no lldp tx-tlv dot1 command specifies the optional IEEE 802.1 TLVs not to include
in the transmitted LLDPDUs. The syntax for the no lldp tx-tlv dot1 command is
Configuration — System
Variable
Variables
Specifies the port or ports on which to disable LLDP
MED policies.
Specifies the voice network policy to disable.
Specifies the voice signalling network policy to
disable.
Description
The ports affected by the command.
The port description TLV. This TLV is enabled by
default.
The system name TLV. This TLV is enabled by
default.
The system description TLV. This TLV is enabled by
default.
The system capabilities TLV (default value is false: not
included).
The local management address TLV. This TLV is
enabled by default.
Configuring LLDP using ACLI
Value
April 2011 175