System configuration using ACLI
Table 84: default lldp tx-tlv command variables
port <portlist>
port-desc
sys-name
sys-desc
sys-cap
local-mgmt-addr
default lldp tx-tlv dot1 command
The default lldp tx-tlv dot1 command sets the optional IEEE 802.1 organizationally-
specifc TLVs to their default values. The syntax for the default lldp tx-tlv dot1
command is
default lldp tx-tlv [port <portlist>] dot1 [port-vlan-id] [vlan-
name ] [port-protocol-vlan-id] [protocol-identity [EAP] [LLDP]
[STP] ]
Run the default lldp tx-tlv dot1 command in Interface Configuration command
mode.
The following table describes the variables for the default lldp tx-tlv dot1
command.
Table 85: default lldp tx-tlv dot1 command variables
port <portlist>
port-vlan-id
vlan-name
port-protocol-vlan-id
protocol-identity [EAP] [LLDP]
[STP]
172
Configuration — System
Variables
Variables
Description
The ports affected by the command.
The port description TLV. This TLV is enabled by
default.
The system name TLV. This TLV is enabled by
default.
The system description TLV. This TLV is enabled by
default.
The system capabilities TLV (default value is false: not
included).
The local management address TLV. This TLV is
enabled by default.
Description
The ports affected by the command.
The port VLAN ID TLV (default value is false: not
included).
The VLAN Name TLV (default value is none).
The port and protocol VLAN ID TLV (default value is
none).
The protocol identity TLV (default value is none).
April 2011