System configuration using ACLI
•
Setting PoE detection method
•
Show port power status
•
Show port power measurement
Set port power enable or disable
Use the poe-shutdown command to disable PoE to a port.
The syntax for the poe-shutdown command is
poe poe-shutdown [port <portlist>]
Use the no poe-shutdown command to enable PoE to a port.
The syntax for the no poe-shutdown command is
no poe-shutdown [port <portlist>]
In either command, substitute <portlist> with the ports on which PoE is enabled or
disabled.
Run the poe-shutdown and no poe-shutdown commands in Interface Configuration
command mode.
Set port power priority
The poe-priority command sets the port power priority.
The syntax for the poe-priority command is
poe poe-priority [port <portlist>] {critical | high | low}
Table 44: poe-priority parameters
Table 44: poe-priority parameters
port <portlist>
{low | high | critical}
Run the poe-priority command in Interface Configuration command mode.
126
Configuration — System
on page 128
Parameter
on page 128
on page 129
on page 126 outlines the parameters for this command.
Description
The ports to set priority for
The PoE priority for the port
April 2011