System configuration using Enterprise Device Manager
Variable
ChassisType
BkplType
LocalSeg
CurState
LLDP configuration using EDM
Use the information in this section to configure and view Link Layer Discovery Protocol (LLDP)
global and transmit properties for local and neighbor systems:
Configuring LLDP globally using EDM
Use the following procedure to configure LLDP transmit properties and view remote table
statistics.
Procedure steps
1. From the navigation tree, double-click Edit.
2. In the Edit tree, double-click Diagnostics.
3. In the Diagnostic tree, double-click 802.1AB.
4. In the 802.1AB tree, double-click LLDP.
5. On the work area, click the Globals tab.
6. Edit global LLDP transmit properties.
7. Click Apply .
284
Configuration — System
Indicates the chassis type of the device that sent the topology
message.
Indicates the backplane type of the device that sent the topology
message.
Indicates if the sender of the topology message is on the same Ethernet
segment as the reporting agent.
Indicates the current state of the sender of the topology message. The
choices are:
• topChanged—Topology information has recently changed.
• heartbeat—Topology information is unchanged.
• new—The sending agent is in a new state.
Value
April 2011