System configuration using ACLI
Asset ID string configuration using ACLI
This section describes the procedures you can perform to configure an asset ID for the switch
or stack using ACLI commands.
Configuring Asset ID string
Perform this procedure to configure asset ID of a switch or stack.
Prerequisites
Log on to Global configuration mode.
Procedure steps
1. To configure asset ID enter the following command:
2. To verify the asset ID settings enter the following command:
Variable definitions
Use the data in the following table to complete the command in this procedure.
Stack
Unit
WORD
198
Configuration — System
asset-id [stack|unit <1-8>] <WORD>
show system
Variable
Value
Sets the Asset ID of the stack
Sets the Asset ID of a specific unit
Sets the Asset ID of the unit on which it is the
console
April 2011