Displaying Interfaces - Avaya 4524GT Configuration Manual

System configuration using ACLI
The syntax for the ip address unit command is
ip address unit <1-8> [A.B.C.D]
Run the ip address unit command in Global Configuration command mode.
The following table describes the parameters this command.
Table 54: ip address unit parameters
Parameters and
variables
unit <1—8>
A.B.C.D
Important:
When the IP address or subnet mask changes, connectivity to Telnet and the Internet can
be lost.
no ip address unit command
The no ip address unit command sets the IP address for the specified unit in a stack to
zeros (0).
The syntax for the no ip address unit command is
no ip address unit <1-8>
Run the no ip address unit command in Global Configuration command mode.
The following table describes the parameters this command.
Table 55: no ip address parameters
Variable
unit <1—8>
Important:
When you change the IP address or subnet mask, connectivity to Telnet and the Internet
can be lost.

Displaying Interfaces

You can view the status of all interfaces on the switch or stack, including MultiLink Trunk
membership, link status, autonegotiation, and speed.
138 Configuration — System
Sets the unit you are assigning an IP address.
Enter IP address in dotted-decimal notation.
Zeroes out the IP address for the specified unit.
Description
Value
April 2011