Set Power Usage Threshold; Setting Poe Detection Method; Show Port Power Status - Avaya 4524GT Configuration Manual

System configuration using ACLI

Set power usage threshold

The poe-power-usage-threshold command sets the power usage threshold in
percentage on individual units.
By setting the PoE power threshold, you can set a percentage of the total PoE power usage
at which the switch sends a warning trap message. If the PoE power usage exceeds the
threshold and SNMP traps are configured appropriately, the switch sends the
pethMainPowerUsageOnNotification trap. If the power consumption exceeds and then falls
below the threshold, the switch sends the pethMainPowerUsageOffNotification trap.
The syntax for the poe-power-usage-threshold command is
poe poe-power-usage-threshold [unit <1-8>] <1-99>
Table 46: poe-power-usage-threshold parameters
this command.
Table 46: poe-power-usage-threshold parameters
unit <1 - 8>
<1 - 99>
Run the show poe-main-configure command in Global Configuration command mode.

Setting PoE detection method

The poe-pd-detect-type command enables either 802.3af or Legacy compliant PD
detection methods.
The syntax for the poe-pd-detect-type 802dot3af_and_legacy command is
poe poe-pd-detect-type [unit <1-8>] {802dot3af |
802dot3af_and_legacy}
Run the poe-pd-detect-type 802dot3af_and_legacy command in Global
Configuration command mode.

Show port power status

The show port power status command displays the power configuration.
The syntax for the show port power status command is
128 Configuration — System
Parameter
on page 128 outlines the parameters for
Description
The unit for which to set the power threshold.
1—99 percent
April 2011