Managing Poe For A Switch Unit Using Edm - Avaya 4524GT Configuration Manual

System configuration using Enterprise Device Manager

Managing PoE for a switch unit using EDM

Use this procedure to display and manage PoE for a single switch unit.
Procedure steps
1. From the Device Physical View, click a switch unit with PoE ports.
2. From the navigation tree, choose Edit.
3. In the Edit tree, double-click Unit.
4. In the work area, click the PoE tab.
5. In the UsageThreshold%, type a value.
6. To enable the sending of traps if the switch power usage exceeds the configured
7. In the PowerDeviceDetectType section, click a radio button.
8. Click Apply .
Variable definitions
Use the data in the following table to display and manage PoE for a switch unit.
Variable
Power(watts)
OperStatus
Consumption
Power(watts)
UsageThreshold%
216 Configuration — System
threshold percentage, select the NotificationControlEnable check box.
OR
To disable the sending of traps if the switch power usage exceeds the configured
threshold percentage, clear the NotificationControlEnable check box.
Displays the total power (in watts) available to the switch.
Displays the power state of the switch:
• on
• off
• faulty
Displays the power (in watts) being used by the switch.
Lets you set a percentage of the total PoE power usage at which
the switch sends a warning trap message. If the PoE power usage
exceeds the threshold and SNMP traps are appropriately
configured, the switch sends the
Value
April 2011