Prerequisites
Log on to the User EXEC mode in ACLI.
Procedure steps
View AES savings by using the following command:
show energy-saver savings
Important:
If a switch is reset while energy-saver is activated, the PoE power saving calculation may
not accurately reflect the power saving, and in some cases may display zero savings. This
is because the switch did not have sufficient time to record PoE usage between the reset of
the switch and energy-saver being reactivated. When energy saver is next activated, the
PoE power saving calculation will be correctly updated.
Job aid: show energy-saver savings command output
The following figure displays sample output for the show energy-saver savings
command.
Figure 15: show energy-saver savings command output
Viewing the global AES configuration using ACLI
Use the following procedure to review the AES configuration for the switch.
Configuration — System
AES configuration using ACLI
April 2011
207