show poe-port-status [<portlist>]
Substitute <portlist> with the ports for which to display configuration.
Run the show poe-port-status command in Global Configuration command mode.
Show port power measurement
The show port power measurement command displays the power configuration.
The syntax for the show port power measurement command is:
show poe-power-measurement [<portlist>]
Substitute <portlist> with the ports for which to display configuration.
Run the show poe-power-measurement command in Global Configuration command
mode.
General switch administration using ACLI
This section describes the ACLI commands used in general switch administration. This section
contains the following topics:
•
Multiple switch configurations
•
Configuring system IP addresses and boot mode
•
Assigning and clearing IP addresses for specific units
•
Displaying Interfaces
•
Displaying configuration information for ports
•
Setting port speed
•
Initiating a cable diagnostic test using ACLI
•
Enabling Autotopology
•
Enabling flow control
•
Enabling rate-limiting
•
Using Simple Network Time Protocol
•
Configuring local time zone
•
Configuring daylight savings time
•
Clock configuration
•
Custom Autonegotiation Advertisements
Configuration — System
on page 130
on page 138
on page 140
on page 144
on page 145
on page 147
on page 150
on page 154
on page 154
on page 157
General switch administration using ACLI
on page 131
on page 137
on page 139
on page 143
on page 157
April 2011
129