Viewing The Agent And Image Software Load Status Using Acli; Show Boot Command - Avaya 4524GT Configuration Manual

System configuration using ACLI
Important:
When you reset to factory defaults, the switch or stack retains the stack operational mode,
the last reset count, and the reason for the last reset; these three parameters are not reset
to factory defaults.
Viewing the agent and image software load status using
ACLI
The command described in this section is used to display the currently loaded and operational
software status for agent and image loads, either individually or combined, for an individual
switch or a stack.

show boot command

The show boot command displays the currently loaded and operational software load
status.
The syntax for the show boot command is
show boot [diag] [image]
Run the show boot command in User EXEC command mode.
Variable definitions
The following table describes the optional parameters you can enter with the show boot
[diag] [image] command.
Variable
diag
image
Important:
When the currently loaded and operational software status is displayed for a stack, the unit
number is replaced by the word All.
100 Configuration — System
Displays only information for the agent load.
Displays only information for the image load.
Value
April 2011