Epson AcuLaser C2900N Service Manual page 354

Chapter 3 Removal and Replacement Procedures Revision B
RRP3.13 UPPER UNIT (Reference only)
[Removal]
1) Remove the CASSETTE ASSY 250. (RRP2.1)
2) Open the COVER ASSY FRONT MG (PL1.2.1).
Note: Cover the drum of the DRUM CARTRIDGE to avoid exposure to light.
3) Remove the DRUM CARTRIDGE. (RRP4.6)
Note: The FUSING part is very hot. Take added care not to get burned when performing the
service operation.
4) Remove the FUSER UNIT. (RRP6.1)
5) Remove the TONER CARTRIDGE (K), (C), (M), (Y). (RRP5.4)
6) Remove the COVER ASSY TOP. (RRP1.1)
7) Remove the COVER ASSY WINDOW TNR. (RRP1.6)
8) Remove the COVER SIDE R. (RRP1.5)
9) Remove the COVER SIDE L. (RRP1.7)
10) Remove the COVER REAR. (RRP1.3)
11) Remove the SWITCH ASSY INLET MG SFP, COVER INLET. (RRP8.8)
12) Remove the FAN. (RRP8.1)
13) Remove the PWBA ESS SFP. (RRP8.3)
14) Remove the PWBA MCU. (RRP8.9)
15) Remove the CLUTCH ASSY DRV and BEARING REGI. (RRP3.1)
16) Remove the TRANSFER ASSY. (RRP6.3)
17) Remove the one screw (silver, 6mm)
that fixes the grounding terminal of the
HARN ASSY GND (PL1.2.22), release the
HARN ASSY GND and all the harnesses
from the GUIDE HARNESS AC (PL8.2.6).
Note: This step is only 2150cdn.
3 - 100 Confidential
Epson AcuLaser C2900N