Epson AcuLaser C2900N Service Manual page 436

Chapter 3 Removal and Replacement Procedures Revision B
RRP8. ELECTRICAL
RRP8.1 FAN (PL8.1.1)
[Removal]
1) Remove the CASSETTE ASSY 250. (RRP2.1)
2) Open the COVER ASSY FRONT MG (PL1.2.1).
Note: Cover the drum of the DRUM CARTRIDGE to avoid exposure to light.
3) Remove the DRUM CARTRIDGE. (RRP4.6)
Note: The FUSING part is very hot. Take added care not to get burned when performing the
service operation.
4) Remove the FUSER UNIT. (RRP6.1)
5) Remove the COVER ASSY TOP. (RRP1.1)
6) Remove the COVER ASSY WINDOW TNR. (RRP1.6)
7) Remove the COVER SIDE R. (RRP1.5)
8) Remove the COVER SIDE L. (RRP1.7)
9) Remove the COVER REAR. (RRP1.3)
10) Disengage the FAN (PL8.1.1)
connector (P/J503) on the PWBA LVPS
(PL8.2.1), release the harness of the FAN
from the hooks of the DUCT FAN
(PL8.1.2).
11) Release the four hooks of the DUCT
FAN, remove the FAN from the printer.
3 - 182 Confidential
Epson AcuLaser C2900N