Epson AcuLaser C2900N Service Manual page 409

Chapter 3 Removal and Replacement Procedures Revision B
[Replacement]
1) Insert the two studs of the FUSER UNIT
into the holes of the printer.
2) Engage the connector (P/J171) of the
FUSER UNIT by pushing the FUSER
UNIT.
2)
3) Close the TRANSFER ASSY.
4) Close the COVER ASSY FRONT MG.
Note: When the FUSER UNIT is replaced with a new one, perform the following steps.
5) Plug in the power cord to the printer.
6) Initialize the Life Counter of the FUSER UNIT.
3 - 155 Confidential
Epson AcuLaser C2900N