Epson AcuLaser C2900N Service Manual page 430

Chapter 3 Removal and Replacement Procedures Revision B
RRP7.3 GEAR P2 (PL7.1.3), DRIVE ASSY PH (PL7.1.4)
[Removal]
1) Remove the CASSETTE ASSY 250. (RRP2.1)
2) Open the COVER ASSY FRONT MG (PL1.2.1).
Note: Cover the drum of the DRUM CARTRIDGE to avoid exposure to light.
3) Remove the DRUM CARTRIDGE. (RRP4.6)
Note: The FUSING part is very hot. Take added care not to get burned when performing the
service operation.
4) Remove the FUSER UNIT. (RRP6.1)
5) Remove the COVER ASSY TOP. (RRP1.1)
6) Remove the COVER ASSY WINDOW TNR. (RRP1.6)
7) Remove the COVER SIDE R. (RRP1.5)
8) Remove the COVER SIDE L. (RRP1.7)
9) Remove the COVER REAR. (RRP1.3)
10) Remove the CLUTCH ASSY DRV and BEARING REGI. (RRP3.1)
11) Disengage the two connectors (P/J24,
26) on the PWBA MCU (PL8.2.13), release
the harness from the GUIDE HARNESS
AC (PL8.2.6).
12) Disengage the connector (P/J211) of
the DRIVE ASSY MAIN (PL7.1.2), release
all the harness from the hooks of the
DRIVE ASSY PH.
3 - 176 Confidential
Epson AcuLaser C2900N