Key Window Display Position Specification - Mitsubishi F940GOT-SWD-E Operation Manual

Graphic Operation Terminal F940GOT
14.7

Key window display position specification

You can specify the initial display position of the ten-key window displayed to input numerics
and change the ASCII data.
Conventionally, the ten-key window position was fixed at the lower right corner of the screen.
(Refer to Section 3.)
• You can specify the ten-key window display position for each screen in "Window Position" in
"Screen Setting" in the screen creation software.
• Basic operation
- When the ten-key window is opened and closed on the same screen, the ten-key window
is displayed again in the previous position. If a screen is displayed for the first time, the
ten-key window is displayed in the initial screen set for the screen.
- When a screen (A) is displayed, another screen (B) is displayed, then the previous
screen (A) is displayed again, the ten-key window is displayed in the initial position set for
the screen (A) without regard to the ten-key window position displayed on the screen (B).
- On a screen for which the ten-key window initial position is not set, the ten-key window is
always displayed at the lower right corner.
- When the ten-key window initial position is set in a position in which the ten-key window
is protruded from the screen, the initial position start coordinate is corrected so that the
entire ten-key window can be displayed on the screen. (Refer to the figure below.)
When "X: 0, Y: 100" are set
Zero point (0, 0)
X:0
Y:100
When "X: 160, Y: 100" or larger coordinates are set
• In the following setting,
the ten-key window is
protruded from the
screen.
Additional Functions (in Ver. 3.00 or Later) 14
• The ten-key window is displayed in the position in
which the upper left corner of the ten-key window is
located in the specified coordinates. The zero point
in this coordinate system is located at the upper left
corner of the screen.
"X: 300, Y: 220" are set
• The upper left corner coordinates are
automatically corrected so that the
entire ten-key window can be displayed
on the screen.
Coordinates are
automatically corrected
to "X: 160, Y: 100".
14-16