Mitsubishi F940GOT-SWD-E Operation Manual page 190

Graphic Operation Terminal F940GOT
• A touch key can be set in the unit of dot. When more than a half of a mesh is set as a touch
key, the mesh is recognized as the touch key.
Specified
touch key
area
2) Reverse On Touch
When this item is made effective, the touch key is reversed instantaneously when pressed.
3) Trigger
Enter a bit device in the PLC. (Initial value: None)
The touch key is effective only while this bit device remains ON.
4) Key Code
When a key code is entered, the touch key is dedicated to registration of entry code for the
security function or display of the system screen.
Mode/screen
HPP mode
SELECT MODE screen
Other mode
Entry code registration screen
Entry code reset
For other key codes, refer to the appendix.
5) Auto repeat and Simul. press
Auto repeat: Repeats the ON/OFF operation at a constant cycle while the touch key is
pressed and held.
Simul. press: Specifies whether or not the touch key is effective when it is pressed simulta-
neously together with another touch key.
Only two keys can be made effective when pressed simultaneously.
Three or more keys cannot be made effective when pressed simultaneously.
This mesh does not function as the touch key because only less than a half of
this mesh is specified as the touch key.
This mesh functions as the touch key because more than a half of this mesh is
specified as the touch key.
Function screen display
DEVICE MONITOR screen
BFM MONITOR screen
SET CLOCK screen
Creation of Display Screens (FX-PCS-DU/WIN-E) 10
Key code
FF11
FF12
FF14
FF64
FF68
FF69
10-42