Sample Cond - Mitsubishi F940GOT-SWD-E Operation Manual

Graphic Operation Terminal F940GOT
5.2.1

SAMPLE COND.

Set the timing at which sampling is performed. When the sampling condition set here is satis-
fied, a specified data register is accessed and its data is stored.
The sampling condition, trigger (DEVICE) or constant cycle (CYCLIC) can be selected.
• Sampling by trigger
When X, Y, M, S, T or C becomes ON (OFF à ON)
sampling is performed. (D, Z and V cannot be specified.)
• Sampling in constant cycle
A cycle (time interval) can be set within the range of 1 second to 10 days, 23 hours, 59 min-
utes and 59 seconds. Sampling is performed at the specified time interval.
u u u u Basic operation
The SET CONDITION
screen is displayed.
Paragraph 5.2
1) SET
Display the
device input
keyboard.
SET
2)
Display the
ten-key pad.
Screen 1
[ SET CONDITION ]
SAMPLE COND.
DEVICE
SET
SAMPLE COND.
Select "SAMPLE
COND." on the
screen.
Device symbol
Select a bit device among X, Y, M, S, T and C.
0 to 9 ENT
Set date, hour, minute
and second. Set date,
hour, minute and second.
END
M 0 OFF->ON
They are changed over alternately.
DEVICE
Select "DEVICE".
The screen 1 is
displayed.
1) Sampling by trigger
Device No. ENT
Execute
the input.
Screen 2
[ SET CONDITION ]
SAMPLE COND.
CYCLIC
SET 0d 0h 0m 0s
Sampling Mode 5
or OFF (ON à OFF)
CYCLIC
Select "CYCLIC".
The screen 2 is
displayed.
2) Sampling in constant cycle
OFF -> ON
Change over
"OFF -> ON" and
"ON -> OFF".
END
5-5
,