Hpp Mode; Outline Of Hpp Mode - Mitsubishi F940GOT-SWD-E Operation Manual

Graphic Operation Terminal F940GOT
4.

HPP Mode

In the HPP mode, sequence programs (list format) can be edited, devices can be monitored,
and set values and current values can be changed from the GOT to the connected PLC.
4.1

Outline of HPP mode

This paragraph describes the operation procedure to change over to the HPP mode and each
function available in the HPP mode.
u u u u Basic operation
The SELECT MODE
screen is displayed.
Paragraph 2.3
[ HPP MODE MENU ]
[ HPP MODE ]
PROGRAM LIST
PARAMETER
DEVICE MONITOR
LIST MONITOR
ACTIVE STATE MONITOR
BFM MONITOR
PC DIAGNOSIS
• When computer link connection is performed, monitoring and the set value change ranges
are restricted. For the details, refer to Section 1.
HPP MODE
Select "HPP MODE"
on the screen.
• All of the following functions except c) are valid only
when the FX Series PLC is connected.
END
a)
a) PROGRAM LIST (Paragraph 4.2)
b)
Sequence programs stored in the PLC can be
c)
edited in the instruction list format.
d)
b) PARAMETER (Paragraph 4.3)
e)
Parameters stored in the PLC can be edited.
f)
c) DEVICE MONITOR (Paragraph 4.4)
g)
The ON/OFF status and the set value/current value
of arbitrary devices in the PLC can be monitored. In
addition, the ON/OFF status can be forcedly set to
ON/OFF and the set values/current values can be
changed.
d) LIST MONITOR (Paragraph 4.5)
Sequence programs stored in the PLC are dis-
played, and the ON/OFF status of each instruction
is displayed. (Current values of word devices can-
not be displayed.)
e) ACTIVE STATE MONITOR (Paragraph 4.6)
The reference Nos. of states (S) ON in the FX PLC
are displayed.
f) BFM MONITOR (Paragraph 4.7)
The contents can be displayed and changed for
buffer memories in special blocks connected to the
FX
g) PC DIAGNOSIS (Paragraph 4.8)
The error information of the FX Series PLC is dis-
played.
The HPP MODE
screen is displayed.
The screen shown
below is displayed.
/FX PLC.
2N 2NC
HPP Mode 4
4-1