Format Of Manual; Contents Described In Manual; Abbreviations Used In Text - Mitsubishi F940GOT-SWD-E Operation Manual

Graphic Operation Terminal F940GOT
1.3

Format of manual

1.3.1

Contents described in manual

This manual is described in the following format. Use each element of the format for index.
Example:
Graphic Operation Terminal F940GOT
a)
2.
2.1
b)
2.1.1 GOT setup
c)
d)
nImportant point
1.3.2

Abbreviations used in text

The following terms may be abbreviated in the text.
1) MELSEC FX or A Series unit may be abbreviated as "programmable controller" or "PLC".
2) The software kit to create display screens FX-PCS-DU/WIN-E or SWoD5C-GOTRE-PACK
may be abbreviated as "software to create screens" or "screen creation software".
3) A general-purpose computer may be abbreviated as "PC".
4) A floppy disk may be abbreviated as "FD". A floppy disk drive may be abbreviated as "FDD".
5) The graphic operation terminal F940 Series may be abbreviated as "GOT".
6) Devices inside the PLC may be abbreviated as "X" (input), "Y" (output), "M" (auxiliary relay),
"S" (state), "T" (timer), "C" (counter) and "D" (data register). Output contacts of X,Y, M, S, T
and C are called "bit devices". T, C and D are called "word devices". All of them may be
called "devices".
Startup
Startup procedure
MITSUBISHI
a) Section title
Startup 2
Sections 2 to 8 describe operations. Sec-
ti o n s 9 t o 1 3 d e s c r i b e t h e c o n te n ts
required to create screens.
b) Title
The title explains the contents of each
paragraph.
c) Sub title
d) Important point
Terms used in the text are explained and
supplemented.
2-1
Introduction 1
1-7