End Cond - Mitsubishi F940GOT-SWD-E Operation Manual

Graphic Operation Terminal F940GOT
5.2.3

END COND.

Set the timing at which sampling is finished. When the end condition is satisfied, sampling is
finished.
• Sampling end by occurrence
Sampling is finished after the specified number of times (2,000 times maximum).
• Sampling end by time
Sampling is continued until the specified time. However, when data on more than 2,000
times has been acquired, the data acquired so far is deleted from the one acquired at the
1st time and new data is saved (that is, the sampling data is shifted).
• Sampling end by trigger
Sampling is finished when the specified device No. becomes ON or OFF. However, when
data on more than 2,000 times has been acquired, the data acquired so far is deleted from
the one acquired at the 1st time and new data is saved.
u u u u Basic operation
The SET CONDITION
screen is displayed.
Paragraph 5.2
SET
1)
Display the
ten-key pad.
SET
2)
Display the
ten-key pad.
3) SET
Display the
device input
keyboard.
END COND.
Select "END
COND." on the
screen.
0 to 9 ENT
Enter the number of
times.
0 to 9 ENT
Set date, hour, minute
and second.Set date,
hour, minute and second.
Device symbol
Select a bit device among X, Y, M, S, T and C.
They are changed over alternately.
NUMBER TIME
Select "NUMBER". Select "TIME".
The screen 1 is The screen 2 is
displayed. displayed.
1) Sampling end by 2) Sampling start
occurence by time
Device No. ENT
Execute
the input.
Sampling Mode 5
DEVICE
Select "DEVICE".
The screen 3 is
displayed.
3) Sampling end
by trigger
OFF -> ON
Change over
à
"OFF ON" and
à
"ON OFF".
5-7