Connection Of Peripheral Units Of Plc - Mitsubishi F940GOT-SWD-E Operation Manual

Graphic Operation Terminal F940GOT
1.5.3

Connection of peripheral units of PLC

When a general-purpose personal computer is directly connected to the GOT, the two-port
interface FX-2PIF (two-port interface function) is not required.
When one GOT and one peripheral unit for sequence program creation are used for one PLC,
the two-port interface FX-2PIF is required. The system configuration required in this case is
shown below.
When the two-port interface FX-2PIF is used
Graphic operation terminal
F940GOT-SWD/LWD-E
Two-port interface
FX-2PIF
Data transfer cable
FX-422CAB0
FX /FX /FX /FX
0 0S 0N
FX Series
2NC
When the two-port interface function is used, the operation environment should be set for it.
(Refer to the description on "SERIAL PORT" on the SET-UP MODE screen.)
Data transfer cable FX-232CAB-1 (when the RS-232C connector in the PC is 9-pin type),
Data transfer cable FX-232CAB-2
(when the RS-232C connector in the PC is half-pitch, 14-pin type) or
Data transfer cable F2-232CAB-1
(when the RS-232C connector in the PC is 25-pin type)
Connection cable FX-40DU-CAB or Connection cable FX-40DU-CAB-10M
Data transfer cable FX-422CAB or
Data transfer cable FX-422CAB-150
/ FX Series
2N
Programmable controller
Program cable FX-20P-CAB
Data transfer cable AC30R4
A Series (except QnA)
(Refer to Paragraph 1.6.2.)
Motion controller
Introduction 1
1
2
3
1-11