Changeover To System Screen - Mitsubishi F940GOT-SWD-E Operation Manual

Graphic Operation Terminal F940GOT
11.6

Changeover to system screen

Function screens built in the GOT such as the HPP MODE screen, the SAMPLING MODE
screen, the ALARM MODE screen and the OTHER MODE screen can be displayed as user
screens.
11.6.1 Display of system screen
This paragraph describes the method to display a system screen as a user screen (that is, dis-
play a system screen in the screen mode) and the caution on this method.
• A system screen can be displayed by specifying a corresponding screen No. using
the "Change Screen" object. In this case, "Save Current Screen" should be made
effective so that the previous user screen can be displayed after the system screen.
DEVICE MONITOR
"DEVICE MONITOR"
Screen No. 1001
DEVICE MONITOR screen
[ DEVICE MONITOR ]
DEVICE ON
SET
COMMENT
For the system screen No., refer to the appendix.
Touch key
No. 0
Screen No. 0
* MENU *
END
OFF
DEC/HEX
Changeover of Display Screen (FX-PCS-DU/WIN-E) 11
• Screen No. 0 is created as follows.
The "Change Screen" object is set so that screen No.
1001 (DEVICE MONITOR screen) is displayed when
the touch key No. 0 (DEVICE MONITOR) is pressed.
Condition
Control
Bit Device
Input
Touch key
1 Not specified
No. 0
Make sure to set "Save Current Screen"
effective.
• For the operating procedures of each system screen,
refer to description on each mode.
• When the END key is pressed, the previous screen
(screen No. 0 in this example) is displayed again.
Screen
Save Current
No.
Screen
(Direct)
1001 Not effective
11-15