Mitsubishi F940GOT-SWD-E Operation Manual page 262

Graphic Operation Terminal F940GOT
u u u u Storage of word device
• Character codes are stored in word devices in the PLC. The stored data is displayed from
the lower 8 bits as shown below.
Example 1
Word Device : D0
Data Length : 1
Bg
(background color)
(The broken line is
not actually
displayed.)
- A character to be displayed at first should be specified using lower 8 bits.
Example 2
Word Device : D0
Data Length : 1
Example 3
Word Device : D0
Data Length : 2 (D0 and D1)
C D
How the data is stored :
Upper bits
D0 (H) F
D1 (H) 4
n n n n Important point
When the character code is set to "H0" (either for full-width or half-width), characters after that
are not displayed on the screen.
To insert space in a text, store "H8140" (for full-width) or "H20" (for half-width) to the specified
word device.
: When two half-width characters (ASCII codes) are displayed
AB
: When one full-width character is displayed
The required codes (taken from the user defined character set) is :
=F053
The upper and lower two digits of the character
code are reversed.
D0 (H)
: When one full-width character and two half-width characters are displayed
The required ASCII codes (taken from the ASCII code table in the
Appendixes) are :
C =H43 (one-byte character, 8bit)
=F053 (one-byte character, 8bit)
D =H44 (one-byte character, 8bit)
Lower bits
0 4 3
2-word
designation
4 5 3
Creation of Display Screen (SW¨ ¨ ¨ ¨ D5C-GOTRE-PACK) 12
From the ASCII code table offered as appendix,
A=H41
ASCII code
B=H42
Data storage status
D0 (H) 4
Upper bits Lower bits
5 3 F 0
D0 (H)
Upper Lower
2 4 1
B A
Upper bits Lower bits
43 F0 53 44
C D
12-34